Indoor Farmer exists to offer Canadian’s the opportunity to "grow their own" food and medicine. Over the years we have added a large selection of outdoor gardening products to compliment our indoor growing collection.
After the 3rd cycle I had hit my 20 cycle oil limit so it was time to change the oil. This time I took the time to add a flush port to my pump. When I replaced the plumbing with larger diameter brass and a cutoff valve I did not think to add the oil flush out port.
(had to replace the whole galvanized T piece with new wires in it) Seems they are epoxied in there, and in my experience passthroughs are a problem spot, so it's not at all surprizing that there was a slight leak there. In any case, I thanks the folks at HR for sending parts and sticking with me throughout.
the "real" vacuum pumps on those machines, with ultimate vacuum levels a few more demial places over. I've chased many a leak in my time,but it was: A.
If you have a high volume lab, it’s usually a good idea to have more than one to be safe. Freeze drying ice water hash is the #1 way to dry it because it increases your production speed, enhances its color, retains more delicate terpenes, and sharply limits microbial activity.
22F, achieved by dividing nove hours by 110F (the difference in food temps). We both know that the FDer doesn't do linear as the temps fall faster early on and slowly peak to max low temps, but the food freeze time might be a tad more linear than the FDer as food is denser and must be frozen throughout.
I did wonder though, since this is gravity flow and not pressure driven as on a car, if having the filter mounted horizontally might result in using only "half" the filter, as the oil would tend to travel through the low side of the filter -- although in practice, I suppose, as the filter material gets plugged it would force the fluid level higher.
So they have been sitting in my freezer awaiting a time when I was prepared to deal with them - I've told him several times that he isn't going to get usable raspberries out of this - just raspberry powder. I don't think he believes me!
A couple of other points: There are obvious and easy improvements that could be made, such as using a container with a dispensing faucet (think of a lemonade jar, for example). Also, for the technically savvy, Automóvel-mechanic-type person who may be wondering about it, there is an anti-backflow seal that has to be removed from the oil filter, but that can be removed by cutting through it and pulling it out with needle nose pliers, which is easily done.
The alternative was to simpIy cut a small section from the guard at the lowest point and allow the water to run down the front of the panel in a single stream. I am not crazy about the look, but it is absolutely necessary to more info protect my investment and the electronics. If you look carefully you can see the hole in the gutter beneath the center screw.
More often than not, accidental gluten consumption means he loses about 5 pounds, which he can’t afford. Due to the potential of cross contamination, we don’t feel comfortable eating at most restaurants, which makes things tricky when we travel.
Odds are the problem is the vacuum hose or its end connections, the drain valve, or the door gasket. Based upon my experience I'd double check the fittings while installed on the FDer.
Regular maintenance includes cleaning the vacuum pump and ensuring proper drainage after each use; refer to the manufacturer's guidelines for specific maintenance tips.
Slight delay at customs but my head was spinning at how fast this was resolved for something that was out of there control! Bravo!